Question 168Electricity & Electronics - QMED
70% to passWhat should be done when performing maintenance of circuit breaker contacts?
Asmooth roughened contact surfaces with a file
Bapply a thin film of oil on contact surfaces
Cuse a metallic oxide abrasive cloth to dress contacts
Dinspect for wear and misalignment of main contacts
AI Explanation
The correct answer is D) inspect for wear and misalignment of main contacts. When performing maintenance on circuit breaker contacts, the primary focus should be on inspecting the contacts for any signs of wear or misalignment. This is in line with the regulations and best practices for maintaining the safety and reliability of electrical systems. Applying a film of oil or using abrasive materials to dress the contacts could potentially compromise the integrity of the connection and introduce contaminants, which is not recommended. Smoothing roughened contact surfaces with a file may address some issues, but it does not address the underlying causes of wear or misalignment.
Related Questions
Q486:When replacing a fuse with one of a ampere higher rating than the original, whic... Q472:Which of the following statements describes the difference between the primary w... Q136:The illustrated motor fails to start and gives a loud hum when the start button ... Q77:What is the current flow through R1 of the circuit in figure "B" of the illustra... Q295:What can cause uneven wear of the commutator surface on a direct current generat...
Ready to test your knowledge?
Take a Electricity & Electronics - QMED Practice ExamOfficial Resources