Question 446Electricity & Electronics - QMED
70% to passYou are troubleshooting the control circuit shown in figure "A" of the illustration utilizing on-line techniques. With the start button depressed, the following readings are obtained with a voltmeter: (Refer to Illustration EL-0123
AA
BB
CC
DD
AI Explanation
The correct answer is B. This is because when the start button is depressed, the voltmeter should read the voltage at point B, which is the input voltage to the control circuit. The other points (A, C, and D) are internal to the circuit and would not directly indicate the input voltage. The other options are incorrect because A, C, and D do not represent the input voltage to the circuit, which is the key parameter being measured when troubleshooting the control circuit.
Related Questions
Q499:How can a motor be protected from overheating due to sustained motor overload? ... Q456:Which of the following characteristics is most critical in determining the wire ... Q340:What type of electrical diagram is shown in figure "B" of the illustration? Illu... Q108:In terms of units, how is the inductance of a coil measured? Q109:In a three-phase circuit, how far apart are the phase voltages?
Ready to test your knowledge?
Take a Electricity & Electronics - QMED Practice ExamOfficial Resources