Question 478Electricity & Electronics - QMED
70% to passWhich of the following statements represents the FIRST step in seating new brushes on slip rings?
APress the brushes against the slip ring with a wood block.
BApply seating compound under the brushes and run at no load for 2 hours.
CIncrease brush pressure and run at no load for 3 to 4 hours.
DLay sandpaper between the brush and the slip ring and slide the sandpaper back and forth under the brush.
AI Explanation
The correct answer is D) Lay sandpaper between the brush and the slip ring and slide the sandpaper back and forth under the brush. This is the first step in seating new brushes on slip rings. The sandpaper helps to conform the brush surface to the shape of the slip ring, ensuring a proper fit and contact. This process is necessary to ensure good electrical conductivity and minimize brush wear. The other options are incorrect because they represent later steps in the brush seating process, such as applying pressure (A and C) or using a seating compound (B), which should only be done after the initial sandpaper seating.
Related Questions
Q389:If the illustrated device in figure "B" has a step-up ratio of 10 to 1 what volt... Q485:As shown in figure "B" of the illustration, with a digital multimeter set up as ... Q307:As shown in the illustration, if the line voltage is 450 VAC, what would be the ... Q520:In figure "2" of the diagram shown in the illustration, the three phase power tr... Q115:Besides for checking for circuit continuity, what can an ohmmeter be used for in...
Ready to test your knowledge?
Take a Electricity & Electronics - QMED Practice ExamOfficial Resources