Question 60Electricity & Electronics - QMED
70% to passWhich of the following materials is recommended for burnishing the slip rings of an alternator after grinding or turning?
Acanvas wiper
Bsmooth file
Cgrade 00 sandpaper
Dhardwood block
AI Explanation
The correct answer is D) hardwood block. The hardwood block is the recommended material for burnishing the slip rings of an alternator after grinding or turning. Burnishing helps to smooth the surface of the slip rings, which is important for maintaining good electrical contact and preventing excessive wear. A hardwood block, such as maple or oak, provides a firm but slightly abrasive surface that can gently polish the slip rings without causing any damage. The other options, such as a canvas wiper, smooth file, or grade 00 sandpaper, are not recommended for this task as they may be too abrasive or soft, potentially causing damage to the delicate slip ring surfaces.
Related Questions
Q215:What operational information data appears on the nameplates of shipboard AC mot... Q92:The resistance of most conducting materials will change as a result of temperatu... Q377:As shown in the illustration, which of the following statements is correct conce... Q123:One method of testing for a reversed shunt field coil in a DC motor is by connec... Q195:What device is used so that the kilowatt load sharing can be adjusted on paralle...
Ready to test your knowledge?
Take a Electricity & Electronics - QMED Practice ExamOfficial Resources