Question 80Gas Turbine - 1st Asst/Chief
70% to passWhen performing a static check to determine tooth contact, you should use which of the following compounds to coat the gear teeth?
ACopper sulfate.
BAn indelible marker.
CPrussian Blue.
DPersian Blue.
AI Explanation
The correct answer is C) Prussian Blue. When performing a static check to determine tooth contact on gear teeth, Prussian Blue is the recommended compound to use. Prussian Blue is a dark blue pigment that will leave a visible imprint on the gear teeth, allowing you to inspect the contact pattern and ensure proper tooth engagement. This is a standard practice specified in the regulations and guidelines for inspecting gear systems. The other options are not the correct compounds for this purpose. Copper sulfate and Persian Blue are not typically used for gear tooth contact inspection, and an indelible marker would not provide the same clear, controlled imprint as a specialized pigment like Prussian Blue.
Related Questions
Q99:In the marine gas turbine engine shown in the illustration, the 9th stage bleed ... Q91:You are preparing for a borescope inspection of a GE LM2500 gas turbine engine. ... Q49:Which of the following is true concerning the main engine lube oil system of the... Q18:Compressor rotor blade tip curl is usually caused by which of the following? ... Q93:The six borescope ports located in the compressor rear frame casing of the marin...
Ready to test your knowledge?
Take a Gas Turbine - 1st Asst/Chief Practice ExamOfficial Resources