Question 634General Subjects - Assistant Engineer
70% to passWhich lathe tool shown in the illustration would best be used on a work piece to perform a right hand facing operation? Illustration GS-0090
AP
BQ
CR
DV
AI Explanation
The correct answer is C) R. The tool labeled "R" in the illustration GS-0090 would be the best choice for performing a right-hand facing operation on a workpiece. This is because a right-hand facing operation requires a tool with a cutting edge that is angled or swept to the right, which the "R" tool is designed to provide. The other tool options (P, Q, and V) are not specifically suited for right-hand facing operations.
Related Questions
Q233:In order to facilitate separation of oil from an oily-water mixture in an oily-w... Q615:Under the federal regulations of 33 CFR Subchapter O, if a vessel equipped with ... Q95:Indicated high salinity of the distillate discharged from a flash-type distillin... Q273:In the illustration shown, an efficient seal is maintained between the suction c... Q426:Which of the following methods applies to how a vacuum is created by a jet pump ...
Ready to test your knowledge?
Take a General Subjects - Assistant Engineer Practice ExamOfficial Resources