Question 73General Subjects - Assistant Engineer
70% to passAfter adding grease to a ball bearing with a hand-held grease gun, you should _______________.
Aclose the bearing housing drain and add a little extra grease to compensate for air pockets in the bearing
Brun the machine with the bearing housing drain plug open for a short while
Csave the used grease for chemical analysis
Dremove the grease fitting and leave open to allow excess grease to escape
AI Explanation
The correct answer is B) run the machine with the bearing housing drain plug open for a short while. The reasoning is that after adding grease to a ball bearing with a hand-held grease gun, you should open the bearing housing drain plug to allow any excess grease or air pockets to escape. This prevents excessive pressure buildup within the bearing housing, which could damage the bearing. The other options are incorrect because: A) adding extra grease to compensate for air pockets is not recommended, as it can lead to excessive grease buildup; C) saving used grease for analysis is not a standard practice in this situation; and D) leaving the grease fitting open could allow contaminants to enter the bearing.
Related Questions
Q395:Which type of pump would normally be used to transfer fairly large quantities of... Q615:Under the federal regulations of 33 CFR Subchapter O, if a vessel equipped with ... Q471:In the illustrated terminal reheat multiple zone system, what statement represen... Q316:What term is defined as the amount of heat required to convert a unit mass of a ... Q293:In the illustration shown, what is the proper description of the hole represente...
Ready to test your knowledge?
Take a General Subjects - Assistant Engineer Practice ExamOfficial Resources