Question 114General Subjects - 1st Asst/Chief
70% to passAs it pertains to raising and lowering an anchor with a horizontal electro-hydraulic or electro-mechanical anchor windlass, what statement is true?
AThe anchor can be either raised or lowered under power with the windlass by disengaging the wildcat clutch. The anchor can be lowered by gravity by controlling the anchor chain payout with the wildcat manual brake with the wildcat clutch engaged.
BThe anchor can only be raised (and not lowered) under power with the windlass by engaging the wildcat clutch. The anchor can be lowered by gravity by controlling the anchor chain payout with the wildcat manual brake with the wildcat clutch disengaged.
CThe anchor can only be raised (and not lowered) under power with the windlass by disengaging the wildcat clutch. The anchor can be lowered by gravity by controlling the anchor chain payout with the wildcat manual brake with the wildcat clutch engaged.
DThe anchor can be either raised or lowered under power with the windlass by engaging the wildcat clutch. The anchor can be lowered by gravity by controlling the anchor chain payout with the wildcat manual brake with the wildcat clutch disengaged.
AI Explanation
The correct answer is D. The explanation is as follows: With an electro-hydraulic or electro-mechanical anchor windlass, the anchor can be raised or lowered under power by engaging the wildcat clutch. The anchor can also be lowered by gravity by controlling the anchor chain payout with the wildcat manual brake, but in this case, the wildcat clutch must be disengaged. The other options are incorrect because they do not accurately describe the proper operation of the anchor windlass system. For example, options A and C state that the anchor can only be raised (and not lowered) under power, which is incorrect.
Related Questions
Q63:While the illustrated system is operated using the steam supply through "F" the ... Q54:Which device is used to prevent over pressurization of the illustrated distiller... Q25:You are unable to pump out the aft starboard engine room bilge well that is foul... Q334:What would be a legitimate reason why some managers don't delegate authority to ... Q13:The size of ball and roller bearings can be identified by the _______________.
Ready to test your knowledge?
Take a General Subjects - 1st Asst/Chief Practice ExamOfficial Resources