Question 132General Subjects - QMED
70% to passWhen welding with an oxyacetylene outfit, _______________.
Aopen the acetylene valve until the hose pressure is 26 PSIG
Ba flashback of flame into the hose is normal
Ca leaking hose must be repaired by binding with tape
Dopen the acetylene cylinder valve only 1/4 to 1/2 turn and leave the wrench on the valve stem
AI Explanation
The correct answer is D) open the acetylene cylinder valve only 1/4 to 1/2 turn and leave the wrench on the valve stem. The reasoning behind this is that when using an oxyacetylene outfit, you want to minimize the amount the acetylene cylinder is opened to reduce the risk of flashbacks and other potential hazards. Opening the valve only 1/4 to 1/2 turn and leaving the wrench on the valve stem allows for quick shutoff in case of an emergency. The other options are incorrect because: A) opening the acetylene valve to 26 PSIG is too high and can increase the risk of flashbacks, B) a flashback is not normal and indicates a dangerous condition, and C) taping a leaking hose is not a proper repair and can be unsafe.
Related Questions
Q223:If you are cutting external threads by hand and you start the die at an angle, t... Q147:The lathe tools shown as figure "M" in the illustration are commonly known as __... Q254:The shaft sleeve for the pump illustrated is identified by the item numbered as ... Q82:Which of the following statements describes the characteristics of precision man... Q25:Which of the following direct reading gauges would most likely be used in the ap...
Ready to test your knowledge?
Take a General Subjects - QMED Practice ExamOfficial Resources