Question 223General Subjects - QMED
70% to passIf you are cutting external threads by hand and you start the die at an angle, the threads will _______________.
Astraighten out after the third revolution
Bbe out of round on the work
Cbe cut crooked on the work
Dbe rough, weak, and easily broken
AI Explanation
The correct answer is C) be cut crooked on the work. If you start a die at an angle when cutting external threads by hand, the threads will be cut crooked on the work. This is because the die needs to be perpendicular to the work surface in order to cut straight, even threads. Starting the die at an angle will cause the threads to be misaligned and crooked, rather than smooth and uniform. The other answer choices are incorrect because: A) the threads will not straighten out, B) the threads will be out of round, and D) the threads will not necessarily be rough, weak, and easily broken, but rather just crooked in appearance.
Related Questions
Q173:The reading on the micrometer scale shown in figure "D" in the illustration is _... Q367:Which problems can occur if the brake band lining of a wildcat brake becomes exc... Q237:To set the dividers to the proper radius, you should use a _______________. Q4:If both the shell-and-tube lube oil cooler and shell-and-tube jacket water coole... Q270:Which of the pumping systems listed for use aboard ship will most likely use a p...
Ready to test your knowledge?
Take a General Subjects - QMED Practice ExamOfficial Resources