Question 259General Subjects - QMED
70% to passA centrifugal bilge pump requires priming _______________.
Ato initially unload the pump by having its head pressure equal to discharge pressure
Bin order to overcome the potential energy of water in the discharge line
Cprimarily to lubricate the shaft seals
Ddue to the inability of this type of pump to lift water to cover the suction (eye) of the impeller
AI Explanation
The correct answer is D) due to the inability of this type of pump to lift water to cover the suction (eye) of the impeller. Centrifugal bilge pumps require priming because they cannot self-prime. This means they cannot draw water up from below the level of the pump, as the impeller design does not create enough suction to lift the water. Priming the pump is necessary to fill the pump casing with water, allowing the impeller to then push the water out through the discharge. The other answer choices do not accurately describe the priming requirement for a centrifugal bilge pump.
Related Questions
Q269:One of the main differences between a propeller pump and a centrifugal pump is ... Q85:Which bearing will carry the load on two small points diametrically opposite to ... Q101:Under what circumstances could equipment be operated when tagged with DANGER tag... Q203:Which of the files listed is tapered on all sides and used to enlarge rectangula... Q52:The device shown in the illustration is commonly used to_________________ Illust...
Ready to test your knowledge?
Take a General Subjects - QMED Practice ExamOfficial Resources