Question 368General Subjects - QMED
70% to passOverheating of the hydraulic fluid in an electro-hydraulic anchor windlass can result from a/an _______________.
Alow fluid viscosity around the shaft seal
Blow fluid level in the reservoir
Chigh oil level in the sump
Doverload on the pump motor
AI Explanation
The correct answer is B) low fluid level in the reservoir. Explanation: Overheating of hydraulic fluid in an electro-hydraulic anchor windlass is most commonly caused by a low fluid level in the reservoir. When the fluid level is low, the pump is unable to draw sufficient fluid, leading to cavitation and reduced lubrication, which can cause the fluid to overheat. The other options are less likely to be the primary cause of overheating - low viscosity around the shaft seal, high oil level in the sump, or overload on the pump motor - as these would not directly impact the fluid level and ability of the pump to draw adequate fluid.
Related Questions
Q319:Copper tubing is manufactured and classified as type K, L, and M. Which type wou... Q43:What statement is true concerning viscosity index as it applies to lubricating o... Q83:Which of the listed types of bearings is an example of a half bearing? Q213:An aligning punch is commonly used to _______________. Q205:A chisel with a mushroom head should not be used because _______________.
Ready to test your knowledge?
Take a General Subjects - QMED Practice ExamOfficial Resources