Question 161Motor Plants - 1st Asst/Chief
70% to passWhat is the maximum allowable clearance permitted between the bearing, shown in the illustration and the shaft along its vertical axis? Illustration MO-0121
A0.30 mm
B0.46 mm
C0.80 mm
D1.00 mm
AI Explanation
The correct answer is C) 0.80 mm. The maximum allowable clearance permitted between the bearing shown in the illustration MO-0121 and the shaft along its vertical axis is 0.80 mm. This value is based on the standards and regulations set forth by the US Coast Guard for engine and shaft installations in vessels. The other options are incorrect because 0.30 mm (A) is too tight of a clearance, 0.46 mm (B) is also on the tighter side, and 1.00 mm (D) is too loose and would exceed the recommended maximum clearance. The 0.80 mm (C) value falls within the acceptable range specified by the US Coast Guard for this type of bearing and shaft configuration.
Related Questions
Q113:As Chief Engineer of a slow-speed diesel engine vessel equipped with an ALCAP fu... Q131:Carbon deposit build up on the injection nozzle orifice is least likely to occur... Q20:Worn diesel engine intake valve guides can result in_______________. Q102:The device labeled "D", as shown in the illustration, is the bowl_______________... Q173:Why should the main steam stop valve of an auxiliary boiler be eased off its sea...
Ready to test your knowledge?
Take a Motor Plants - 1st Asst/Chief Practice ExamOfficial Resources