Question 10Refrigeration & AC - 1st Asst/Chief
70% to passThe set point adjustment of the device shown in the illustration is made by rotating what component? Illustration GS-RA-14
A"1"
B"2"
C"3"
D"4"
AI Explanation
The correct answer is B) "2". The set point adjustment of the device shown in the illustration GS-RA-14 is made by rotating component "2". This is typically the knob or dial used to adjust the desired set point or threshold value for the device. The other components labeled "1", "3", and "4" are likely related to the overall operation and function of the device, but do not directly control the set point adjustment. The other answer choices are incorrect because they do not correspond to the component responsible for adjusting the set point, as indicated in the illustration.
Related Questions
Q118:Through which of the components shown in the illustration is flash gas formation... Q30:Traditionally, which of the listed refrigerants has been more suitable than the ... Q138:What is the drive arrangement of refrigeration compressor shown in figure "B" of... Q76:When installing a mechanical shaft seal on a refrigeration compressor, extreme c... Q158:If the superheat setting of a thermostatic expansion valve is set too low, what ...
Ready to test your knowledge?
Take a Refrigeration & AC - 1st Asst/Chief Practice ExamOfficial Resources