Question 138Refrigeration & AC - QMED
70% to passFor most multi-box refrigeration systems, the refrigerant sight glass would be located where in the system?
Aafter the receiver in the liquid line
Bafter the condenser in the drain line to the receiver
Cafter the compressor in the discharge line
Dbefore the compressor in the suction line
AI Explanation
The correct answer is A) after the receiver in the liquid line. The refrigerant sight glass is typically located in the liquid line after the receiver because this is the best location to observe the state of the refrigerant. The receiver is where the liquid refrigerant collects, so placing the sight glass here allows you to see if the refrigerant is fully condensed and free of bubbles, which indicates proper system operation. The other options are incorrect because the sight glass would not be located in the discharge line (C), the suction line (D), or the drain line to the receiver (B), as these are not the optimal locations to observe the refrigerant state.
Related Questions
Q37:The amount of HCFC-123 in a storage cylinder is measured by what means? Q63:After the refrigerant has been recovered, leaks repaired if necessary, the syste... Q132:What is the drive arrangement of refrigeration compressor shown in figure "B" of... Q107:Concerning the operation of refrigeration systems, frosting or sweating of a liq... Q23:When removing the primary refrigerant from a system using water as a secondary r...
Ready to test your knowledge?
Take a Refrigeration & AC - QMED Practice ExamOfficial Resources