Question 666Steam Plants - Assistant Engineer
70% to passThe jacking/turning gear mechanism of a main propulsion geared turbine installation is normally connected through mechanical linkage to the _______________.
Ahigh-speed pinion rotor
Blow-speed pinion rotor
Clow-speed gear rotor
Dbull gear
AI Explanation
The correct answer is A) high-speed pinion rotor. The jacking/turning gear mechanism is typically connected to the high-speed pinion rotor of a main propulsion geared turbine installation. This allows the rotor to be turned slowly during maintenance or startup procedures, without engaging the full power of the turbine. The other options are incorrect because: B) The low-speed pinion rotor is not directly connected to the jacking/turning gear. C) The low-speed gear rotor is also not the component connected to the jacking/turning gear. D) The bull gear is a large, slow-turning gear, and is not the component connected to the jacking/turning gear.
Related Questions
Q310:Insufficient air for combustion in a boiler furnace could result in a __________... Q730:Guardian valves are installed on main propulsion turbines to _______________. Q407:Coast Guard Regulations Q460:If a centrifugal main feed pump were operated at shutoff head with the recircula... Q201:Under normal conditions, the rate of heat transfer in a feed water heater is mos...
Ready to test your knowledge?
Take a Steam Plants - Assistant Engineer Practice ExamOfficial Resources