Question 155Steam Plants - QMED
70% to passThe jacking gear on main propulsion turbines can be used to _______________.
Alift the reduction gear casing
Bprovide propulsion in emergencies
Cprovide reduction gear tooth inspection
Dreduce turbine speed during maneuvering
AI Explanation
The correct answer is C) provide reduction gear tooth inspection. The jacking gear on main propulsion turbines is used to slowly rotate the turbine shaft, allowing for visual inspection of the reduction gear teeth. This allows the engineer to check the condition of the gear teeth without the turbine running at full speed. The jacking gear does not provide propulsion in emergencies (B), nor is it used to lift the reduction gear casing (A) or reduce turbine speed during maneuvering (D). The primary purpose of the jacking gear is to facilitate routine inspection and maintenance of the reduction gears, which is a critical safety requirement for the proper operation of the main propulsion system.
Related Questions
Q45:An efficient seal is normally obtained between the upper and lower halves of a t... Q88:In addition to sensing steam drum water level, what additional sensing input doe... Q128:According to the illustrated auxiliary steam and HP bleed steam system diagram, ... Q182:Excessive recirculation of condensate should be avoided, as it can cause _______... Q191:When cleaning boiler fuel oil atomizer parts, what type of cleaning tool should ...
Ready to test your knowledge?
Take a Steam Plants - QMED Practice ExamOfficial Resources