Question 4236Deck General70% to pass
You are stopped with no way upon your vessel at the pilot station. Your vessel is a large twin-screw ship. You must come around 180° to board your Pilot. How should you use the engines and rudder to turn the ship fastest in the least amount of space?
AI Explanation
The correct answer is D) Half ahead with hard over rudder, then full astern on inboard engine.
This technique, known as a "Williamson Turn," is an effective way to turn a large twin-screw ship around in a tight space. By first going half ahead with hard over rudder, the ship will start to turn. Then, by going full astern on the inboard engine, the ship will pivot and complete the 180-degree turn quickly and efficiently, without excessive use of engine power.
The other options are less effective. A) and B) would not generate enough turning force, while C) could cause the ship to lose control and potentially damage the engines.
Related Questions
#4234 A twin-screw vessel can clear the inboard propeller and maneuver off a pier best by holding a(n) _______________.#4235 You are conning a twin-screw vessel going ahead with rudders amidships. If the port screw stops turning the bow will _______________.#4237 In twin-screw engine installations while going ahead, maneuvering qualities are most effective when the tops of the propeller blades both turn _______________.#4238 The DEEP DRILLER is loaded as shown in the Sample Load Form #1 (Transit). Although winds are less than 70 knots, excessive motion requires ballasting to survival draft. Assume that 4087 long tons of ballast are added at an average VCG of 8.32 feet, and upon arrival at 45 feet, port and starboard ballast tanks 1, 3, and 8 are slack. What will be the new margin on the maximum allowable KG? #4239 To what distance below the hull must the legs of the COASTAL DRILLER be lowered in order to meet the stability and leg strength requirements during the wind speeds greater than 70 knots?