Question 4350Deck General70% to pass
The maximum transverse extension of the cantilever for the COASTAL DRILLER places the rotary _______________.
AI Explanation
The correct answer is B) within 10 feet of the centerline.
The maximum transverse extension of the cantilever for the COASTAL DRILLER places the rotary within 10 feet of the centerline. This is likely due to stability and balance requirements for the vessel's design and operation. Placing the rotary too far off-center could negatively impact the vessel's stability and handling characteristics.
The other options are incorrect because:
A) Placing the rotary at the vessel's TCG (Transverse Center of Gravity) would not meet the 10-foot centerline requirement.
C) Placing the rotary 40 feet aft of the transom is too far back and would not align with the cantilever's maximum transverse extension.
D) Placing the rotary at the leg centroid is not specified as the requirement in this case.
Related Questions
#4348 You are operating a liftboat. In preparation for jacking you should _______________.#4349 During the passage of a severe storm the maximum vertical moments, including free surface moments, permitted on the DEEP DRILLER at survival draft is _______________.#4351 Among the valves on the DEEP DRILLER to open when using the Salt-Water Service Pump to pump water into tank 10S is _______________.#4352 When two ballast pumps used for deballasting a single tank start cavitating, you should _______________. #4353 While preloading, the COASTAL DRILLER has a total weight of 21,401 kips. The LM are 2,560,416 ft-kips, and the TM are 6,206 ft-kips. What is the bow leg reaction?