Question 4627Deck General70% to pass
For a floating MODU, the center of flotation is the point in the waterplane _______________.
AI Explanation
The correct answer is A) about which the MODU lists and trims.
The center of flotation is the point in the waterplane about which a floating body, such as a MODU (Mobile Offshore Drilling Unit), lists and trims when subjected to external forces. This is because the center of flotation is the point where the buoyant forces act, and any list or trim of the MODU will occur around this point.
The other options are incorrect because:
B) refers to the center of buoyancy, not the center of flotation.
C) describes the relationship between the center of gravity and the center of buoyancy, not the center of flotation.
D) is incorrect, as the center of flotation does not necessarily coincide with the center of buoyancy.
Related Questions
#4625 The DEEP DRILLER, at a draft of 45 feet and total vertical moments of 981,567 ft- long tons, floods 2068.7 long tons of sea water through the overboard discharge into tanks 3 and 8 on both sides. The VCG of the added ballast is 7.22 feet. The shift in the height of the center of gravity is _______________.#4626 While drilling ahead with 60 foot draft, the DEEP DRILLER encounters lost circulation and loses 900 Bbls. of 16 pounds per gallon mud to the hole. How much ballast must be taken on to maintain 60 foot draft? #4628 The DEEP DRILLER is loaded as shown in the Sample Load Form #1 (transit). What is the new metacentric height corrected for transverse free surface effects if the entire contents of Salt Water Ballast Tanks 1P and 1S are discharged? (Use KMT = 375.38 feet) #4629 The most important consideration in the event the Deep Driller suffers damage is _______________.#4630 The DEEP DRILLER, at a mean draft of 60 feet, has a two-foot trim by the head and a three foot list to starboard. What is the draft at the port aft draft mark?