Question 171Electricity/Electronics - Assistant Engineer70% to pass
Before working on an electric cargo winch master switch or controller, what should be done?
AI Explanation
The correct answer is B) open the circuit breaker in the power supply and tag-out.
This is the correct answer because before working on any electrical equipment, it is crucial to isolate the power source to prevent accidental energization, which could lead to serious injury. Opening the circuit breaker and tagging it out ensures that the power is disconnected and cannot be turned on while work is being performed. This is a standard safety practice required by electrical safety regulations and best practices.
The other answer choices are incorrect because they do not properly isolate the power source. Heating the switch box, draining condensate, or spraying the gasket surface do not prevent the equipment from being energized, which is the primary safety concern when working on electrical systems.
Related Questions
#169 The current at which a magnetic-type overload relay tends to trip may be decreased by raising the plunger further into the magnetic circuit of the relay. What effect does this action have? #170 High-pressure compressed air should not be used to clean electric motors or controller equipment. Why not? #172 Why are electric strip heaters used in motor controllers? #173 If a self-excited DC generator running at rated speed fails to deliver an output voltage, which of the following conditions may be a cause of this difficulty? #174 What can cause uneven wear of the commutator surface on a direct current generator?