Question 39Electricity/Electronics - 1st Asst/Chief70% to pass
What problem with a printed circuit board may resolve itself once a board is removed from its edge card connector and then reinstalled?
AI Explanation
The correct answer is B) Corroded pin connectors.
Corroded pin connectors on a printed circuit board can sometimes resolve themselves once the board is removed from its edge card connector and then reinstalled. This is because the act of removing and reinserting the board can help break through any corrosion buildup on the connector pins, restoring the electrical connection.
The other options are incorrect because: A) Leaking components would not be resolved by removing and reinserting the board, C) Open traces or broken connections would likely not fix themselves in this manner, and D) Discolored or darkened components are usually a sign of more permanent damage that would not be resolved by this action.
Related Questions
#37 Which of the following procedures should be used to maintain a large electric motor during periods of inactivity? #38 When troubleshooting a printed circuit board, one technique that can be used is swapping the suspected damaged board with a new board. If a board extraction system is not available, what technique should be used to remove the suspected damaged board that is plugged into its edge card connector horizontally? #40 As shown in the illustrated adaptive digital steering control system functional block diagram and listed system interface signals table, what would the rudder order signal output voltage to the rudder servo amplifier be for a rudder order of 20 degrees left rudder, assuming left rudder signals are negative and right order signals are positive in polarity? Illustration EL-0191 #41 As shown in the illustrated adaptive digital steering control system functional block diagram and listed system interface signals table, what would the rudder order signal output voltage to the rudder servo amplifier be for a rudder order of 15 degrees right rudder, assuming left rudder signals are negative and right order signals are positive in polarity? Illustration EL-0191 #42 As shown in the illustrated echo sounding display unit and control panel and pertinent operating characteristic tables, what situation would require increasing the unit gain? Illustration EL-0186