Question 147Electricity/Electronics - QMED70% to pass
By what means is the burning of controller contacts due to arcing, when opening, prevented?
AI Explanation
The correct answer is C) magnetic blowout coils.
Magnetic blowout coils are used to prevent the burning of controller contacts due to arcing when opening the circuit. The magnetic field created by the coils helps to quickly extinguish the arc, reducing the chances of contact damage and prolonged arcing. This is an effective way to prevent contact damage and ensure the safe operation of electrical equipment.
The other options are not the primary means of preventing contact arcing when opening a circuit. Coating the contacts with petroleum jelly (A) may help reduce arcing, but it is not the primary method. Overvoltage (B) and overcurrent (D) releases are designed to protect the circuit from excessive voltage or current, but they do not specifically address the issue of contact arcing when opening the circuit.
Related Questions
#145 A single-phase capacitor-start induction motor starts, comes up to about 75% rated speed, slows down to a lower speed, and accelerates again. Where is the problem most likely to be? #146 A digital multimeter is set up as shown in the illustration to evaluate the single-circuit stator windings of a squirrel cage induction three-phase motor. The following readings are taken: From T1 to T2 reads "OL" ohms. From T2 to T3 reads "OL" ohms. From T3 to T1 as shown reads "1.6" ohms. What condition is indicated? Illustration EL-0219 #148 As shown in figure "B" of the illustration, when the DC motor in figure "A" is operating at minimum speed what are the armature and field characteristics? Illustration EL-0153 #149 As shown in the illustrated electrically operated watertight door controller, how is the rotation direction of the door motor reversed? Illustration EL-0115 #150 In the illustrated views of a lead-acid battery as shown in figures "A" and "B", what battery component has the sole function of preventing the individual plates in the negative plate group from coming into direct contact with the individual plates in the positive plate group? Illustration EL-0031