Question 197General Subjects - Assistant Engineer70% to pass
To convert a vane type hydraulic pump to a hydraulic motor, which of the following would have to be done?
AI Explanation
The correct answer is A) Provide small springs between the vanes and the base of the vane slots.
To convert a vane-type hydraulic pump to a hydraulic motor, the key change is to provide small springs between the vanes and the base of the vane slots. This allows the vanes to be pushed outward by the springs, creating the necessary suction to draw in fluid and generate rotational motion, rather than just pumping fluid. The other options, such as adding an extra vane, increasing casing thickness, or installing an enlarged control ring, are not the primary modifications required to convert a pump to a motor.
Related Questions
#195 If the flow rate and pressurized oil from a variable capacity pump were supplied to the device illustrated the _______________. Illustration GS-0058 #196 The device illustrated would be best used as a _. Illustration GS-0058 #198 A two-stage hydraulic pump unit is used to _______________.#199 Both the direction of flow and fluid flow rate of a variable displacement radial piston pump are determined by the relative positions of the _______________.#200 The hydraulic tubing installation shown as figure "D" is INCORRECT and will probably leak when in operation because the tubing _______________. Illustration GS-0065