Question 509General Subjects - Assistant Engineer70% to pass
To get an accurate measurement using a 12 inch machinist's steel rule, you should measure _______________.
AI Explanation
The correct answer is D) from the one inch graduation mark.
To get an accurate measurement using a 12 inch machinist's steel rule, you should measure from the one inch graduation mark, not the zero end of the scale. This is because the zero end of the rule is not always perfectly aligned, and measuring from the one inch mark ensures you are getting an accurate 12 inch measurement.
The other options are incorrect because: A) the unmarked edge may not be precisely calibrated, B) measuring on the narrow edge would not provide the full 12 inch length, and C) measuring from the zero end could introduce inaccuracies.
Related Questions
#507 Which of the devices shown in the illustration is designed for both inside and outside measurements? Illustration GS-0073 #508 To measure the circumference of a piece of pipe, you should use a _______________.#510 Which of the figures in illustration GS-0080 would be used in conjunction with figure "B" of the device shown in illustration GS-0124? Illustrations GS-0080 and GS-0124 #511 Which of the figures illustrated is not suitable for use as a hex head set screw? Illustration GS-0080 #512 With regards to the American National Screw Thread nomenclature, 'pitch' is the _______________.