Question 309General Subjects - 1st Asst/Chief70% to pass
As a chief engineer you are reviewing the engine room logbook. You must insure that all entries are made properly. What should be your criteria for how a watch officer makes a correction to an incorrect log entry?
AI Explanation
The correct answer is D) The incorrect entry should have a thin line drawn through the error and be initialed by the person making the correction so that the incorrect entry is still visible.
This is the correct answer because it follows the proper procedure for making corrections to logbook entries. The key principles are transparency and accountability - the incorrect entry should remain visible, and the person making the correction should identify themselves. Completely obliterating, disguising, or erasing the incorrect entry would go against these principles and could be seen as an attempt to cover up or falsify the record.
The other options are incorrect because they do not preserve the original entry or identify the person making the correction, which is essential for maintaining the integrity and accuracy of the logbook.
Related Questions
#307 As a management level engineering officer on a motor vessel equipped with engines capable of burning both high sulfur content residual fuels and low sulfur content distillate fuels, on approaching arrival to a US port, for planning purposes, what must be done? #308 As a management level engineering officer, you are apt to be the primary investigator investigating the root cause of the failure of a piece of machinery. In collecting the necessary data for the root cause analysis, what should be your FIRST priority? #310 If it is desired to perform a thermo graphic analysis of a piece of equipment with a suspected possible fault and compare the thermal signature with similar fault-free equipment, what is the name of the thermography performed? #311 When using a thermal imager for the purpose of conducting a thermo graphic analysis of equipment, what form of energy produces the thermal signature radiating from the object surface? #312 If it is desired to perform a thermo graphic analysis of new equipment to gain a thermal signature for purposes of comparison to the thermal signature for the same equipment at a later date, what is the name of the thermography performed on the equipment when new?