Question 410General Subjects - 1st Asst/Chief70% to pass
According to 46 CFR regulations pertaining to periodic tests and inspections as related to machinery and equipment, what functional test must be performed on boiler draft fans, fuel oil transfer and service pumps, and machinery space ventilation fans during periodic inspections?
AI Explanation
The correct answer is A) Remote shutdown capability.
According to 46 CFR regulations, during periodic inspections, boiler draft fans, fuel oil transfer and service pumps, and machinery space ventilation fans must be tested for their remote shutdown capability. This ensures that these critical components can be safely and quickly shut down from a remote location in the event of an emergency or malfunction.
The other options, such as remote run status indication, remote speed change, and remote startup capability, are not specifically required by the regulations for these particular pieces of equipment during periodic inspections. The focus is on verifying the remote shutdown functionality to maintain safe operation and control of the vessel's machinery and systems.
Related Questions
#408 As a chief engineer, which of the following instructions would be most appropriately entered into the Chief Engineer's night orders due to the non-routine nature of the instruction? #409 As a chief engineer, which of the following instructions would most appropriately be written into the chief engineer's night orders due to the non-routine nature of the special instruction? #411 Planned maintenance procedures are important to maintaining the operating condition of equipment. Your vessel is a single screw vessel. How often should you exam your vessel's tail shaft in order to be in compliance with Coast Guard periodic testing and inspection regulations? #412 Suppose a water-lubricated stern tube bearing is being evaluated for wear where the propulsion machinery is located amidship. If the tailshaft diameter is 10.5 inches, according to 46 CFR regulations pertaining to periodic tests and inspections as related to machinery and equipment, what would be the maximum clearance diameter permissible before the bearing must be re-bushed? #413 If two centrifuges are to be simultaneously used in series to treat residual fuel contaminated with both water and solids, how should the centrifuges be configured?