Question 85General Subjects - 1st Asst/Chief70% to pass
The floating end of a shell-and-tube type cooler utilizes a packing ring to _______________.
AI Explanation
The correct answer is A) prevent leakage past the floating end tube sheet.
The packing ring in a shell-and-tube type cooler is used to form a seal between the floating end tube sheet and the shell, preventing leakage of the cooling medium (typically water) past the tube sheet. This is necessary to ensure the cooling medium flows through the tubes as intended, maximizing the heat transfer efficiency of the cooler.
The other answer choices are incorrect because they do not accurately describe the purpose of the packing ring in this type of cooler. Option B is irrelevant, option C is too general, and option D describes a different function of the cooler design.
Related Questions
#83 When performing a hydrostatic test on a low pressure evaporator to determine the source of suspected air leaks you should use _______________.#84 Sacrificial zinc anodes are used on the saltwater side of heat exchangers to _______________.#86 The thickest deposit of scale in a flash evaporator is most likely to occur in the tubes of the _______________.#87 On which of the following heated surfaces of a flash type evaporator would you be more likely to find soft scale formation? #88 In the operation of a two-stage flash type distilling plant, the rate of scale formation is greatly reduced by _______________.