Question 276General Subjects - QMED70% to pass
Which of the listed types of steam end piston rod packing should be used in a steam reciprocating pump?
AI Explanation
The correct answer is C) High-pressure graphite packing.
High-pressure graphite packing is the appropriate choice for a steam reciprocating pump, as it is designed to withstand the high temperatures and pressures associated with steam systems. Graphite packing provides excellent sealing properties and can effectively prevent steam leaks in the piston rod area of the pump.
The other options would not be suitable - reinforced rubber packing (A) is not rated for high-temperature steam service, wire-impregnated high-temperature packing (B) may not provide the necessary sealing under high pressures, and low-pressure braided asbestos packing (D) is not appropriate for the demands of a steam reciprocating pump.
Related Questions
#274 When repacking a reciprocating pump with more than four rings of packing, the packing is cut square, installed with the ends abutted, and each succeeding ring staggered with the butted ends _______________.#275 To safely remove the piston rod packing from the steam end of a reciprocating pump, you should _______________.#277 An increase in rotor clearances in a rotary pump will _______________.#278 An inadequate reciprocating bilge pump discharge is most often caused by _______________.#279 Excessive lost motion in the valve mechanism of a duplex reciprocating pump will cause the _______________.