Question 164Motor Plants - 1st Asst/Chief70% to pass
When an additional load is applied to a diesel engine which is using an inadequately inflated air bladder clutch unit, you can expect_______________.
AI Explanation
The correct answer is D) overheating because of slipping shoes.
When an additional load is applied to a diesel engine using an inadequately inflated air bladder clutch unit, the clutch shoes will begin to slip against the drum. This slipping action creates friction and heat, leading to overheating of the clutch assembly. The other options are incorrect because they do not directly result from the slipping clutch scenario described in the question.
Excessive wear on thrust bearings, pneumatic seizure, and chipped reduction gear teeth could occur due to other issues with the diesel engine or transmission system, but they are not the primary consequence of a slipping air bladder clutch under increased load.
Related Questions
#162 What is the normal bearing clearance permitted at the horizontal axis of the shaft for the bearing shown in the illustration? Illustration MO-0121 #163 After following the prescribed procedures to measure the thrust bearing clearance shown in the illustration, the distance "F" is determined to be 200 mm, and 'f1' is 2.3 mm. Which of the following statements describes the condition indicated by these dimensions? Illustration MO-0121 #165 Misalignment of the drive shaft and propeller shaft flanges can be detected by using a dial indicator or _______________.#166 The gear drive, shown in the illustration, can have the backlash determined best by using a_______________. Illustration MO-0091 #167 The thrust bearing shown in the illustration has over eight years of ahead running time. Measurements show "i1" is 4 mm and "i2" is 1mm. Which of the following conditions is indicated and what steps should be taken, if any? Illustration MO-0121