Question 38Motor Plants - QMED70% to pass
A modern centrifuge, similar to the device shown in the illustration, is opened for periodic cleaning. The most common cause of operating failure after reassembling is due to _______________. Illustration MO-0012
AI Explanation
The correct answer is D) not replacing the bowl O-rings that have taken a permanent set.
The most common cause of operating failure after reassembling a modern centrifuge is due to the failure to replace the bowl O-rings that have taken a permanent set. Over time, the constant exposure to heat, pressure, and vibration can cause the O-rings to deform and lose their sealing ability. If the O-rings are not replaced during periodic maintenance, the centrifuge may experience leaks, uneven operation, or even a catastrophic failure when reassembled and put back into service.
The other answer choices are not the most common causes of failure. Low drive motor RPM, excessive back pressure, and issues with the water supply are less likely to occur compared to the degradation of the critical O-ring seals.
Related Questions
#36 If fuel oil were being discharged from the waste water outlet of a fuel oil disk type centrifuge, operated as a separator, you should _______________.#37 Heat damage to fuel injection nozzles can be prevented by avoiding _______________.#39 One cause of diesel engine surging can be a result of _______________.#40 The maximum pressure developed by a waste heat boiler is determined by the main engine exhaust _______________.#41 An exhaust gas bypass is installed on a waste heat boiler in order to _______________.