Question 66Refrigeration/AC - 1st Asst/Chief70% to pass
When pumping down an air conditioning system to test the low-pressure cutout switch, assuming that the compressor is running, what should be done to initiate the test?
AI Explanation
The correct answer is C) close the "king" valve.
To test the low-pressure cutout switch in an air conditioning system, you need to gradually reduce the pressure in the system. Closing the "king" valve, which is the main refrigerant service valve, will isolate the compressor and allow the pressure to drop, triggering the low-pressure cutout switch. This is the proper method to initiate the test without stopping the compressor or other components.
The other options are incorrect because stopping the compressor (A), securing the condenser (B), or stopping the circulating pump (D) would not properly test the low-pressure cutout switch by gradually reducing the system pressure.
Related Questions
#64 To add refrigerant to the high side of an air conditioning system, you should close the king valve and introduce the refrigerant through what valve in what state? #65 The compressor used in a water-cooled air conditioning system is short-cycling. A service check determines that the suction pressure remains above the normal cut-in point during cycling and that the discharge pressure rapidly builds up to the cut-out point while running and gradually falls to the cut-in point during the off cycle. What is likely the cause? #67 Using the illustrated chart giving the boiling point of moisture at various depths of vacuum, with an ambient temperature of 72°F, what depth of vacuum would be associated with the BEST chance of achieving a dehydration evacuation with a deep vacuum pump? Illustration GS-RA-56 #68 When recovering the remaining R-134a refrigerant from the centrifugal chiller shown in the illustration as a vapor using the recovery unit's compressor, in addition to opening valves "1a", "1b", and the compressor suction and discharge isolation valves, which of the following would be the correct valve lineup? Illustration GS-RA-28 #69 The air temperature associated with a direct reciprocating air conditioning plant is found to be too warm, and the compressor is not operating. A service check determines the compressor suction pressure to be above the normal cut-in point, with a normal head pressure, and high evaporator superheat. Which of the following could be the cause of this problem?