Question 177Safety & Environmental - Assistant Engineer70% to pass
After measuring the length to which a section of shoring should be cut, you should cut the shoring _______________.
AI Explanation
The correct answer is B) approximately 1/2 inch shorter than the measured length to allow for the use of wedges.
When cutting a section of shoring, you want to leave a small amount of extra space to allow for the use of wedges. Wedges are used to tightly secure the shoring in place and prevent any movement or shifting. By cutting the shoring approximately 1/2 inch shorter than the measured length, you provide the necessary space to insert the wedges without the shoring being too tight or difficult to install.
The other answer choices are incorrect because: A) allowing for wet expansion is not necessary for this type of shoring installation, C) cutting the shoring longer than the measured length would make it more difficult to fit and secure, and D) cutting it to the exact measured length would not leave room for the wedges.
Related Questions
#175 A flat block placed under the end of a shore for the purpose of distributing pressure is referred to as a _______________.#176 The wooden shoring shown in the illustration is bearing against the hatch coaming and is supporting a load in the direction indicated by the arrows. Which of the following statements is correct for this condition? Illustration SF-0018 #178 Wooden shoring is used in shipboard damage control to _______________.#179 After an emergency shoring installation has been completed, the _______________.#180 The wooden plug fitted tightly in the vent of a damaged tank may prevent the tank from _______________.