Question 321Steam Plants - Assistant Engineer70% to pass
In automatic combustion control systems, increasing or decreasing a loading pressure by a set amount is called _______________.
AI Explanation
The correct answer is A) biasing.
In automatic combustion control systems, increasing or decreasing a loading pressure by a set amount is referred to as "biasing". Biasing involves adjusting the loading pressure, which is the pressure applied to the fuel supply, in order to maintain the desired combustion parameters. This is a key function of automatic combustion control systems.
The other answer choices are incorrect because:
B) Relaying refers to the transmission of a signal, not the adjustment of loading pressure.
C) Loading refers to the actual fuel supply, not the act of adjusting it.
D) Transmitting is similar to relaying, referring to the communication of a signal, not the biasing of a pressure.
Related Questions
#319 A photoelectric cell is installed in an oil fired boiler safeguard system to introduce proper resistance values to the electronic control circuit. This device is primarily sensitive to _______________.#320 As found in a basic pneumatic automatic combustion control system, the function of a standardizing relay is to _______________.#322 The component labeled "F" as shown in the illustration is_______________ Illustration SG-0007 #324 The entire unit which houses the burner, air scoop, air doors and bladed cone is correctly called the _______________.#325 Which of the terms listed represents the ratio between the highest and lowest fuel oil pressure at which the burners will remain ignited?