Question 85Electricity & Electronics - QMED
70% to passWhich of the following conditions would most likely lead to the failure of a resistor due to overheating?
AResistor wattage rating one-half that required for the circuit.
BResistor wattage rating two times higher than that required for the circuit.
CResistor wattage rating four times higher than that required for the circuit.
DResistor wattage rating equal to that required for the circuit.
AI Explanation
The correct answer is A) Resistor wattage rating one-half that required for the circuit. This is because if the resistor wattage rating is one-half of what is required for the circuit, the resistor will be subjected to excessive power dissipation, leading to overheating and potential failure. The other options (B, C, and D) would not lead to overheating and failure, as the resistor wattage rating would be sufficient or even higher than required for the circuit.
Related Questions
Q348:Which type of flux should be used when soldering electrical wire connections for... Q260:Capacitors can be used in electric distribution systems to improve power factor.... Q156:What is an ohmmeter used to measure? Q218:What is the wattage of a heating element drawing a current of 30 amperes, at 120... Q446:You are troubleshooting the control circuit shown in figure "A" of the illustrat...
Ready to test your knowledge?
Take a Electricity & Electronics - QMED Practice ExamOfficial Resources