Question 393Steam Plants - 1st Asst/Chief
70% to passJournal bearings used with modern turbine rotors are manufactured in two halves in order to _______________.
Afacilitate interchanging with other bearing halves
Bprovide for positive oil flow at all loads
Cpermit removal of the bearing without removing the rotor from the turbine
Dmaintain axial alignment and reduce thrust
AI Explanation
The correct answer is C) permit removal of the bearing without removing the rotor from the turbine. Journal bearings used with modern turbine rotors are manufactured in two halves to allow the bearing to be removed and replaced without having to remove the entire rotor from the turbine. This design feature facilitates maintenance and repair, as the rotor can remain in place while the bearing halves are replaced as needed. The other answer choices do not directly relate to the purpose of the two-piece bearing design.
Related Questions
Q266:While underway, the boiler water level in a steaming boiler begins dropping rapi... Q404:When the flow of oil admitted to a disk-type centrifugal purifier is in excess o... Q150:Which of the listed types of safety valves is shown in the illustration? Illustr... Q361:The three wing device in the unit illustrated is maintained in its position by i... Q295:In a steam turbine and reduction gear main propulsion plant, the alarm sensor fo...
Ready to test your knowledge?
Take a Steam Plants - 1st Asst/Chief Practice ExamOfficial Resources