Question 4617Deck General70% to pass
In MODU construction, bulkheads in the quarters are generally _______________.
AI Explanation
The correct answer is D) non-structural.
In MODU (Mobile Offshore Drilling Unit) construction, bulkheads in the quarters (living areas) are generally non-structural, meaning they are not intended to provide significant structural support to the vessel. These bulkheads are primarily used for partitioning and defining the interior spaces, rather than serving as critical structural components.
The other answer choices are incorrect because: A) continuous bulkheads may be found in other areas of the MODU, but not necessarily in the quarters; B) watertight bulkheads are typically found in the hull and other critical areas to maintain the vessel's integrity, but not necessarily in the quarters; and C) structural bulkheads are used to provide the main support for the MODU's overall structure, but the bulkheads in the quarters are not considered part of the primary structural system.
Related Questions
#4615 The DEEP DRILLER, while loaded as shown in the Sample Load Form #4 (Drilling), suffers damage to the starboard center column below the waterline. Pumping from tanks 2S and 9S is not sufficient to prevent increasing starboard list. You should consider counterflooding in tank _______________.#4616 The DEEP DRILLER, loaded as shown in Sample Load Form #5 (Survival), suffers major damage which results in flooding in tank C1P. Your best countermeasure is to pump from _______________.#4618 A semisubmersible in transit is at a draft of 19 feet. The depth of the lower hulls is 21 feet. How much bunker fuel at 54.0 lbs/cu ft could be taken on and still provide one foot of freeboard if the TPI is 52.3? #4619 While the DEEP DRILLER is loaded as shown in Sample Form #4 (Drilling), casing is accidentally dropped on the starboard side. Because the sounding level and starboard aft inclination are slowly increasing, you decide that tank 10S has minor damage. Among the possible corrective actions is _______________.#4620 The DEEP DRILLER, at a draft of 60 feet, has a KGL of 55.4 feet and an LCG of 2.43 feet. What is the trim angle?