Question 408Electricity/Electronics - Assistant Engineer70% to pass
Refer to figure "A" representing an electric oven as shown in the illustration. With the oven turned on, the power available indicator light is off, the oven on indicator light is off, and only elements "6" and "7" appear to be producing heat. Which fuse is blown? Illustration EL-0041
AI Explanation
The correct answer is A) L1 10A line fuse is blown.
This is because with the power available indicator light off, the oven on indicator light off, and only elements 6 and 7 producing heat, it indicates a loss of power on one of the line fuses, most likely the L1 10A line fuse. The other line fuses (L2 and L3) would need to be intact for the other elements to be producing heat.
The other options are incorrect because a blown L2 or L3 line fuse would result in a different pattern of heating elements, and a blown L1 control fuse would typically cause all the indicator lights and heating elements to be off, not just some elements.
Related Questions
#406 A digital multimeter is set up as shown in the illustration to test an individual element of a three-phase immersion heater. The elements are connected across terminals 1 and 4, 2 and 5, and 3 and 6 as shown. The reading across terminals 1 and 4 is 32 ohms. The reading across terminals 2 and 5 is 32 ohms. The reading across terminals 3 and 6 as shown is "OL" ohms. What condition is indicated? Illustration EL-0216 #407 Which of the following conditions will occur if the brake solenoid coil burns out on a cargo winch with an electrical brake? #409 The winch shown in the illustration operates in any of the positions with the master switch in the 'lower' direction, but will not 'hoist' in any of the master switch hoist speed positions. Which of the listed faults could be the cause? Illustration EL-0102 #410 Refer to figures "1" and "2" of the basic synchronous transmission system shown in the illustration. Figure "1" shows a properly connected system where the receiver TR remains in correspondence with the transmitter TX. In figure "2", although properly zeroed, the receiver goes out of correspondence with the transmitter due to improper connections resulting in reverse torque direction. Which connection error results in this behavior? Illustration EL-0149 #411 As shown in the illustration, which brush holder is of the reaction type? Illustration EL-0029