Question 160General Subjects - Assistant Engineer70% to pass
While starting a hydraulic anchor windlass, you observe that hydraulic pressure does not develop in spite of the proper operation of the electric drive motor. Which of the following actions should you take FIRST to restore pressure?
AI Explanation
The correct answer is D) Make certain that the hydraulic reservoir is filled to the proper level.
The first step in troubleshooting a hydraulic anchor windlass system where pressure is not developing is to check the hydraulic fluid level in the reservoir. Without sufficient hydraulic fluid, the system will not be able to build up the necessary pressure to operate the windlass, even if the electric motor is functioning properly. Checking the fluid level is the most basic and logical first step to restore pressure in the hydraulic system.
The other options, while potentially useful troubleshooting steps, are not the first action that should be taken. Inspecting the motor brake, checking voltage supply, and verifying the overload relay are all secondary steps that should only be considered after confirming the hydraulic fluid level.
Related Questions
#158 In a shell-and-tube type hydraulic fluid cooler, the amount of heat transferred from the hydraulic fluid to the cooling water depends upon _______________.#159 Overheating of the oil in a hydraulic system can be caused by _______________.#161 You press start button on the hydraulic power unit shown in the illustration, and the motor does not start. The first thing you should check is the _______________. Illustration GS-0161 #162 Overheating of a hydraulic system may be a result of _______________.#163 If a hydraulic pump is producing a noisy whine when in operation, the cause may be _______________.