Question 414General Subjects - 1st Asst/Chief70% to pass
Which of the following statements represents acceptable practice for heavy fuel oil settling tank heating?
AI Explanation
The correct answer is D) When filled, the heat source to the settling tank should be cut in until the ideal settling temperature is reached, then secured allowing the fuel to remain undisturbed for as long as possible.
This is the correct practice because maintaining the ideal settling temperature, typically around 95-104°F (35-40°C), is important to allow for proper separation of water and sediment from the heavy fuel oil. Once the ideal temperature is reached, the heat should be secured to avoid disturbing the settling process and allow the contaminants to fully separate by gravity. Keeping the fuel undisturbed for an adequate period is crucial for effective settling. The other options are incorrect as they either keep the heat on constantly, disturb the settling process, or do not provide any heat at all, which would not achieve the necessary temperature for proper separation.
Related Questions
#412 Suppose a water-lubricated stern tube bearing is being evaluated for wear where the propulsion machinery is located amidship. If the tailshaft diameter is 10.5 inches, according to 46 CFR regulations pertaining to periodic tests and inspections as related to machinery and equipment, what would be the maximum clearance diameter permissible before the bearing must be re-bushed? #413 If two centrifuges are to be simultaneously used in series to treat residual fuel contaminated with both water and solids, how should the centrifuges be configured? #415 Which of the following statements represents acceptable practice for heavy fuel oil storage tank heating? #416 For the most efficient centrifuging of residual fuels on motor vessels, the lower the viscosity of the fuel as achieved by preheating, the more efficiently solids and moisture can be removed. For planning purposes, what is the typically the recommended upper limit of preheating for residual fuel oil centrifugation on motor ships? #417 In new construction or during significant steel plate replacements, what is the procedure of 'line heating'?