Question 222General Subjects - QMED70% to pass
When internal threading for piping where the work permits the tap to be run entirely through you can begin and end the tapping of the hole by using a _______________.
AI Explanation
The correct answer is A) taper tap.
When internal threading for piping where the work permits the tap to be run entirely through, a taper tap should be used. Taper taps are designed with a gradual taper at the starting end, which allows the tap to easily enter and start the threading process. This taper also helps guide the tap through the full length of the hole, enabling you to begin and end the tapping smoothly.
The other options are not appropriate in this scenario. Bottoming taps are used for threading blind holes, plug taps are for general-purpose threading, and finishing taps are used to clean up and refine the threads after initial tapping.
Related Questions
#220 A pipe, or Stillson wrench functions best when _______________.#221 If you are hand tapping holes in cast iron, you should _______________.#223 If you are cutting external threads by hand and you start the die at an angle, the threads will _______________.#224 The proper tool used for cutting new external threads is called a thread _______________.#225 The names plug, bottom, and taper refer to _______________.