Question 4342Deck General70% to pass
What port-side valves must be open to transfer ballast from Tank 1P to Tank 10P on the DEEP DRILLER using the Port #1 ballast pump?
AI Explanation
The correct answer is C) 1, 33, 43, and 24.
To transfer ballast from Tank 1P to Tank 10P using the Port #1 ballast pump, the following port-side valves must be open:
- Valve 1: Connects the Port #1 ballast pump to the ballast system
- Valve 33: Allows flow from Tank 1P to the ballast manifold
- Valve 43: Allows flow from the ballast manifold to Tank 10P
- Valve 24: Allows the ballast to be discharged from Tank 10P
The other answer choices are incorrect because they either include unnecessary valves or do not include all the required valves for this specific ballast transfer operation.
Related Questions
#4340 On the DEEP DRILLER, when using the starboard #2 ballast pump to provide water to the main deck from the sea, it is necessary to open valves _______________.#4341 For a jack-up, the angle of maximum stability corresponds approximately to the angle of _______________.#4343 A semisubmersible is more likely to experience structural stresses during heavy weather when _______________.#4344 What port-side valves must be open to transfer ballast from Tank 10P to Tank 1P on the DEEP DRILLER, using the Port #1 ballast pump? #4345 The COASTAL DRILLER, elevated in 100 feet of water with 0 knots current, 30 foot waves, and wind speeds of 50 knots may continue drilling if the maximum leg reaction is less than_______________.