Question 4298Deck General70% to pass
What should be done after repairing a surface crack on a link of anchor chain by grinding?
AI Explanation
The correct answer is C) Examine the area by magnetic particle inspection.
After repairing a surface crack on a link of anchor chain by grinding, it is important to inspect the area using magnetic particle inspection. This non-destructive testing method can detect any remaining cracks or other defects in the chain link that may have been missed or created during the grinding process. Proper inspection is crucial to ensure the integrity and safety of the repaired chain before it is placed back into service. The other options, such as post-heat treatment (A) or galvanizing (B), are not sufficient to verify the structural soundness of the repair. Replacing the entire chain (D) may not be necessary if the inspection confirms the repair was successful.
Related Questions
#4296 During preloading or elevating the COASTAL DRILLER, jacking-up may continue if the total weight is less than _______________.#4297 While loaded as shown in the COASTAL DRILLER sample load form #3 (drilling), 200 kips are discharged from 60 feet AF0 and 30 feet to starboard of the centerline. What is the starboard leg reaction? #4299 Prior to magnetic particle inspection of anchor chain, the chain should be _______________.#4300 On the DEEP DRILLER, among the starboard-side valves to open when flooding through the overboard discharge into ballast tank 1S is valve _______________.#4301 When taking soundings on a MODU, coating the tape with chalk helps to _______________.